I have a craftmans 1 1/4 hp belt sander and can"t because that the life that me figure out how to change the belt. I discovered the tracking knob and a bar on the side(which i feel should relocate to ease the belt yet doesn"t) can any type of one help me please give thanks to you Bob
The craftsman belt sander I have uses the adhering to proceedure to change the belt.The prior roller is feather loaded and when that is placed againt a heavy surface favor the front sheet of her workbench, you press on the belt sander and the roller retracts back until it engages a bracket and also releases the stress and anxiety on the belt.You then change the belt and also locate the bracket that is hold the roller ago and use a flat blade screwdriver to release it. The roller then snaps forward and also tensions up the brand-new belt. Hope this helps.

You are watching: Changing belt on craftsman belt sander


*

*

*

My Craftsman 4x21" 7.5 amp sander provides a lever on the side between the rollers come unload spring pressure; if yours has a lever that does seem to do anything maybe the bar linkage is disconnected/broken.jws
If you walk to http://www.sears.com and also click top top parts, girlfriend can enter your design # right into their database and it will pull up every the repair components on it.Hardly an "assembly manual" yet I have seen just how things are put together and also sometimes the jogs my memory or puts points in perspective so ns can obtain it walk again
*
.Good luck.
The craftsman belt sander I have actually uses the complying with proceedure to change the belt.The former roller is feather loaded and also when it is put againt a hard surface like the front sheet of her workbench, you press on the belt sander and also the roller retracts earlier until the engages a bracket and releases the anxiety on the belt.You then readjust the belt and also locate the bracket that is hold the roller back and use a flat blade screwdriver to release it. The roller then breaks forward and tensions increase the new belt. Hope this helps.
I have adhered to your indict too but cannot find the relax bracket to connect the prior roller after ~ I have put ~ above the new sand file belt!
It is a level bar ~ above the side the you pull out (hard) to relax the tension and also spring the prior wheel out. Because you have actually fiddled with the tracking knob, you will require to readjust the track as soon as you spool it increase one time.

See more: A Mystery Of Heroism Stephen Crane : "A Mystery Of Heroism", Stephen Crane’S Portrayal Of War In A Mystery Of


This thread assisted me but did"nt really define well how to release the springloaded record mechanism. First, unplug the sander. The an essential seems come be that you should release push on the locking bar in the same manner you provided to lock it as defined above. Ie. Put the prior roller top top the leaf of a workbench and pushing the roller earlier towards the back roller. Even after the system is locked you have the right to still use pressure in this manner come ease stress on the locking bar. While using pressure, reach into the center of the sander (somewhere in between the front and also rear rollers) and with a pair the pliers acquire hold that the bar and also pull out. It have to release. To refine the location of the belt top top the rollers apply pressure on the former roller together if your were attempting to lock it yet not so lot as will reason it to lock. The hand works fine to use pressure. However remember to unplug.