It is encourage to adjust transmission fluid every 30,000-50,000 miles in your hand-operated transmission Toyota Corolla (see maintenance schedule). Monitor this picture guide to do this maintenance item; most civilization I speak to agree it is even less complicated than one oil change!

When girlfriend buy through links on this site, I might earn one affiliate the supervisory board – in ~ no expense to you.

You are watching: 2007 toyota corolla transmission fluid capacity

These actions should use to any kind of 2003-2008 manual transmission (C59 – 5-speed manual) Toyota Corolla. The car shown right here is a 2004. The form of transmission liquid required in this transmissions is GL-4 hands-on transmission fluid.

The Toyota C59 is a 5-speed hands-on transmission offered in Toyota 4-cylinder, 1.8 liter front-wheel journey cars beginning in ~2004. In enhancement to Toyota Corollas, the C59 has also been set up in the Toyota Celica, Matrix, and MR2, and additionally includes some general Motors cars as well.

Tools and supplies used:2 qts of GL-4 hand-operated transmission liquid (I use and also highly introduce Red heat MT-90)

Procedure come Drain and Fill hands-on Transmission Fluid

Park the car on a level surface ar and collection the parking brake.Position a drainpipe pan under the transmission drainpipe plug.Remove the fill plug using a 24mm socket wrench.Remove the drain plug utilizing a 24mm socket wrench permitting the fluid to drain out.

Detailed Procedure – action by Step

The transmission has two ports linked with the transmission fluid, a drain port and a fill port. The drainpipe port is situated near the bottom of the transmission, and the fill port is located at part distance over the drainpipe port. You recognize you have the exactly amount of liquid in the transmission once the liquid is simply up come the fill port (just around to leak out), and also not below. The exactly amount of fluid is listed in her owner’s manual.

The an initial step is to remove the fill plug. Why, you ask? Well, both the drain and fill plugs have the right to get an extremely tight. Over there is a slight opportunity you will have actually trouble remove the plug, or damage it when removing it. Girlfriend don’t desire to finish up in this situation with an empty transmission! Also, the liquid will drain far better with the to fill plug removed.

The fill plug is most easily access from the top, so pop the hood and prop it up.

The fill port is clearly shows in this photo, between the battery and also the engine, means down in there.

*

The to fill plug is located at the facility of this photo,

*

Here is a contempt closer view.

*

Position something because that the liquid to drain into, in case it was overfilled previously. In this case I supplied a 1 gallon ice cream cream pail.

*

Use a 15/16″ socket, to ease the fill port (note: if technically a 24mm plug, I discover that the 15/16″ socket fits much more snugly). A 6″ socket expansion was valuable for this step, however may no be strictly necessary.

*

The to fill port plug was rather tight because that me, for this reason I used a pipeline “cheater bar” to boost the mechanical benefit so knuckles didn’t gain bashed.

*

The to fill plug removed. Notice the to like washer.

*

Wipe the to fill plug off through a rag, then change the to like washer v a brand-new one.

*

Now move under the vehicle and also locate the drainpipe plug. That is situated at the bottom of the transmission. Position a drainpipe pan under it.

*

Use the very same 15/16″ socket to remove the drain plug.

*

*

The transmission fluid will begin draining out.

After the old transmission fluid has drained out, clean increase the drainpipe plug and also put a new crush washer top top it. Tighten the drain plug to 29 lb-ft with a talk wrench.

*

We’re currently ready to add transmission fluid. A great way to know about how much fluid to add, is to poor the liquid you drained out, right into something the you can measure on, such together a milk jug, ice cream cream pail, etc… Then make a note on the side, and also clean that out. As soon as it is saturated clean, fill the container as much as your mark with fresh fluid. This is the amount you should include (assuming that you started with the exactly amount in the an initial place!). Ns usually uncover that I require to add that much, and also a tiny more…

In general, a drain and fill such as this will certainly require precisely 2 quarts.

The manual transmission Toyota Corolla requires 75W-90 GL-4 infection fluid. I use and also recommend the Red line MT-90.

In order to to fill the infection fluid, we require to acquire a funnel the can enter in the fill port. I use a lengthy transmission fluid funnel, and also put a little extra item of water tap on the finish to do the bend.

*

*

Position the funnel (or tubing, if making use of that) so the it is right into the to fill port.

*

*

Add fluid until it starts draining out. It should be around 2 qts.

Then, re-install the fill port plug, don’t forget the new crush washer.

*

Plug with new crush washer installed.

See more: What Part Of The Cow Does Steak Come From A Cow, Does Steak Come From Cows Or Bulls

*

Tighten it come 29 lb-ft through your torque wrench.

And that’s around it! i hope this was advantageous to you!

For an ext helpful guides on Toyota Corollas, check out this posts!

Tools and also supplies used:2 qts that GL-4 manual transmission liquid (I use and also highly recommend Red heat MT-90)